MATERIAL SAFETY DATA SHEET

This MSDS complies with OSHA'S Hazard Communication Standard 29 CFR 1910.1200 and OSHA Form 174 

IDENTITY AND DISTRIBUTOR'S INFORMATION

NFPA Rating: Health-2; Flammability-2; Reactivity-0; Special-

HMIS Rating: Health-2; Flammability-2; Reactivity-0; Personal Protection-G

Manufactured For: K-CHEM, INC.

Address: P.O.Box 530632

Address: Birmingham, AL 35253

DOT Hazard Classification: ORM-D

Identity (trade name as used on label):

RIGHT STUFF

Phone: (205)592-0844

MSDS Number:

EMERGENCY RESPONSE NUMBER: 1(800)255-3924

NOTICE: JUDGMENT BASED ON INDIRECT TEST DATA

Date Prepared: 08/20/036

Information Calls: (205)592-0844

SECTION 1 - MATERIAL IDENTIFICATION AND INFORMATION

COMPONENTS-CHEMICAL NAMES AND COMMON NAMES

(Hazardous Components 1% or greater; Carcinogens 0.1% or greater)

CAS Number

SARA

III LIST

OSHA PEL

(ppm)

ACGIH

TLV (ppm)

Carcinogen

Ref. Source **

Orange Terpenes (< 95.0% by weight)

68917-57-7

No

N/E

N/E

d

 

 

 

 

 

 

N/E= Not Established   N/A= Not Applicable

 

 

 

 

 

SECTION 2 - PHYSICAL/CHEMICAL CHARACTERISTICS

Boiling Point: 300-400°F

Specific Gravity (H2O=1): 0.82

Vapor Pressure: PSIG @ 70°F (Aerosols): N/A

Vapor Pressure (Non-Aerosols)(mm Hg and Temperature): 1.0

Vapor Density (Air = 1): 4.7

Evaporation Rate ( Butyl Acetate= 1): N/E

Solubility in Water: Emulsifies

Water Reactive: N/E

Appearance and Odor: Clear, Orange liquid with citrus/ orange odor

SECTION 3 - FIRE AND EXPLOSION HAZARD DATA

FLAMMABILITY as per USA FLAME PROJECTION TEST (aerosols) N/A

Auto Ignition Temperature

N/E

Flammability Limits in Air by % in Volume:

% LEL: N/E % UEL: N/E

FLASH POINT AND METHOD USED (non-aerosols): 122 degrees F (T.O.C. method)

SPECIAL FIRE FIGHTING PROCEDURES: Wear a self contained breathing apparatus with a full face piece operated in the positive pressure demand mode with chemical resistant personal protective equipment.

EXTINGUISHER MEDIA: Dry chemical, CO2 or foam is recommended.

Unusual Fire & Explosion Hazards: N/E

SECTION 4 - REACTIVITY HAZARD DATA

STABILITY [ X ] STABLE [ ] UNSTABLE

HAZARDOUS POLYMERIZATION [ ] WILL [ X ] WILL NOT OCCUR

Incompatibility (Mat. to avoid): Absorbent clay, acids or oxidizers

Conditions to Avoid: High Temperature

Hazardous Decomposition Products: CO, CO2

SECTION 5 - HEALTH HAZARD DATA

PRIMARY ROUTES OF ENTRY: [ X ] INHALATION [ ] INGESTION [ X ] SKIN ABSORPTION [ X ] EYE [ ] NOT HAZARDOUS

ACUTE EFFECTS:

Inhalation: Can cause nose, throat and respiratory tract infection, coughing and headache.

Eye Contact: May cause mild eye irritation. Symptoms include stinging, tearing and redness.

Skin Contact: May cause mild to moderate skin irritation. Prolonged or repeated contact may dry the skin. Symptoms include redness, burning, drying of the skin and skin burns.

Ingestion: Harmful if swallowed. may cause nausea, vomiting and diarrhea.

CHRONIC EFFECTS: No data.

Medical Conditions Generally Aggravated by Exposure: Prolonged or repeated exposure can cause drying, defatting and dermatitis of skin.

EMERGENCY FIRST AID PROCEDURES

Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention immediately.

Skin Contact: Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Get medical attention immediately.

Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.

Ingestion: Seek medical attention immediately. Call a poison control center or doctor for treatment advice. have person drink water if able to swallow.

SECTION 6 - CONTROL AND PROTECTIVE MEASURES

Respiratory Protection (specify type): When respiratory protection is required, use an organic vapor cartridge. A respiratory program that meets OSHA's 29 CFR 1910.34 & ANSI Z88.2 requirements must be followed.

Skin Protection: To prevent repeated or prolonged contact, wear impervious gloves (made from rubber, nitrile, or neoprene), clothing and boots.

Eye Protection: Wear safety glasses or goggles.

Ventilation Requirements: Good general ventilation required.

Other Protective Clothing & Equipment:

Hygienic Work Practices: Do not eat, drink or smoke in work area. Wash immediately on contact.

SECTION 7 - PRECAUTIONS FOR SAFE HANDLING AND USE

Steps To Be Taken If Material Is Spilled Or Released: Stop all leaks. Isolate hazard area. Keep unnecessary and unprotected personnel from entering. Absorb spill with inert material- DO NOT use clay-type absorbent materials. Eliminate all ignition sources. Prevent runoff from entering drains, sewers, streams or other bodies of water. Absorb unrecoverable product. Transfer contaminated absorbent, soil and other materials to containers for disposal.

Waste Disposal Methods: Waste must be disposed of in accordance with federal, state and local environmental control regulations.

Precautions To Be Taken In Handling & Storage: Follow all MSDS/ label precautions even after container is emptied because they may contain product residues. Use with adequate ventilation. Do not get in eyes, on skin or on clothing. Store in a cool, dry place. Keep container closed when not in use.

Other Precautions &/or Special Hazards: KEEP OUT OF THE REACH OF CHILDREN. Do not transfer or store in plastic containers for long periods of time.

We believe the statements, technical information and recommendations contained herein are reliable, but they are given without warranty or guarantee of any kind.

** Chemical Listed as Carcinogen or Potential Carcinogen. [a] NTP [b] IARC Monograph [c] OSHA [d] Not Listed [e] Animal Data Only

THIS MSDS IS CURRENT AS OF June 12. 2005. The DATE PREPARED section is the original date assembled and remains current until a change is necessary. This is tracked internally at the manufacturer by these date codes and therefore must remain as the originating date.